Duplicator 4S Stampanti 3D in Metal Frame Black
Updated 10 September 2026 · Live prices updated daily
Buy on Amazon.it - €226.00 →Affiliate link. Price live from the marketplace, not cached.
At a glance
What this printer gets right and wrong
- ✓ Under €300 - low-risk way to get into 3D printing without regretting the spend.
- ! Max hot-end temp only 230°C - PLA-dominant territory, no PETG with any safety margin.
- ! 5.0 L build volume - fine for calibration prints and small parts, awkward for anything bigger than a mug.
Head-to-head spec + price table against the WANHAO Duplicator 4S Stampanti 3D in Metal Frame Black. Verified printers on this marketplace only.
Sensible first-printer territory: priced where you can afford to get it wrong, with auto-levelling so the first layer isn't a ritual. You'll outgrow it in 18 months, which is fine.
Bedslinger with middling flow rate - you already have one of these. The whole point of upgrading is speed, rigidity, or print quality that your current machine can't hit. This doesn't clear that bar.
No active heated chamber or a hot end that tops out below 280°C means no reliable ABS, ASA, nylon or PC. Fine for a hobbyist, wrong tool for commercial work in engineering materials.
Verdicts are rule-driven from the spec sheet and current price (€226). They don't capture firmware polish, support quality, or reliability - so treat them as a sanity check, not a final answer.
Live offers
Every live listing on the English-language Amazon marketplaces that I've matched to this printer. Cheapest first. Affiliate links.
Close alternatives - what $226 gets you elsewhere
Think of this like the shopping-cart upsell: here's what a tenner more or less could buy you in roughly the same category. Same FDM tech, same marketplace, all prices live. Stretches are data-driven; they're not sponsored placements.
Save the money, same build volume at 14.2 L. You'd give up: nothing obvious on the spec sheet.
Get: 6.6 L more build volume (11.6 L) · 300°C hot end (was 230°C).
Get: 12.6 L more build volume (17.6 L) · 300°C hot end (was 230°C).
Frequently asked
What materials can the WANHAO Duplicator 4S Stampanti 3D in Metal Frame Black print? +
At €226 the WANHAO Duplicator 4S Stampanti 3D in Metal Frame Black realistically prints PLA and TPU. The 230°C hot end is too tight for PETG with confidence and rules out ABS/nylon entirely.
How fast is the WANHAO Duplicator 4S Stampanti 3D in Metal Frame Black? +
Middle of the pack. 6.67 mm³/s volumetric flow is enough for typical hobby prints but will be the bottleneck on large-infill parts or anything with dense walls. The 40 mm/s headline is motion-system capable, not hot-end sustainable.
How big can I print on the WANHAO Duplicator 4S Stampanti 3D in Metal Frame Black? +
225×145×150 mm (5.0 L). Small build area. Fine for calibration prints, minis, keychains, small functional parts. Awkward for anything bigger than a coffee mug.
Is the WANHAO Duplicator 4S Stampanti 3D in Metal Frame Black worth €226? +
€226 is the sweet spot tier. The WANHAO Duplicator 4S Stampanti 3D in Metal Frame Black competes directly with the current Bambu A1, Creality K1 and Prusa Mini generation. Hardware-per-pound is tight here - the differentiator is usually software polish and ecosystem.
