CR-6 Max Maximum Build Volume 400x400x400mm CR 6
Updated 8 September 2026 · Live prices on every page load from Amazon US + UK
Buy on Amazon.com - $749.97 →Affiliate link. Price live from the marketplace, not cached.
At a glance
What this printer gets right and wrong
- ✓ 64.0 L build volume - room for helmets, large functional parts, bulk runs.
- ! Bedslinger design - expect ringing artefacts on tall prints at speed.
- ! Open frame - PLA and PETG only, realistically. Forget ABS or nylon done properly.
Head-to-head spec + price table against the FilaCube CR-6 Max Maximum Build Volume 400x400x400mm CR 6. Verified printers on this marketplace only.
At this price you're well past the sweet spot for a first printer. There's no shame in starting with something cheaper - you'll learn more on a 200-400 machine and have money left for filament.
Bedslinger with middling flow rate - you already have one of these. The whole point of upgrading is speed, rigidity, or print quality that your current machine can't hit. This doesn't clear that bar.
No active heated chamber or a hot end that tops out below 280°C means no reliable ABS, ASA, nylon or PC. Fine for a hobbyist, wrong tool for commercial work in engineering materials.
Verdicts are rule-driven from the spec sheet and current price ($750). They don't capture firmware polish, support quality, or reliability - so treat them as a sanity check, not a final answer.
Live offers
Every live listing on the English-language Amazon marketplaces that I've matched to this printer. Cheapest first. Affiliate links.
- 🇺🇸 CR-6 Max 3D Printer Maximum Build Volume 400x400x400mm CR 6 MaxAmazon.com · New$749.97View
Close alternatives - what $750 gets you elsewhere
Think of this like the shopping-cart upsell: here's what a tenner more or less could buy you in roughly the same category. Same FDM tech, same marketplace, all prices live. Stretches are data-driven; they're not sponsored placements.
Save the money, similar specs on paper. You'd give up: 64.0 L vs 49.0 L build volume.
Get: 320°C hot end (was 260°C) · a proper heated chamber, so ABS/ASA/nylon become realistic.
Get: 350°C hot end (was 260°C).
Frequently asked
What materials can the FilaCube CR-6 Max Maximum Build Volume 400x400x400mm CR 6 print? +
At $750 the FilaCube CR-6 Max Maximum Build Volume 400x400x400mm CR 6 is a PLA, PETG, TPU machine. The 260°C hot end covers PETG with a small safety margin. ABS and nylon need an enclosure plus more heat - not this printer.
How big can I print on the FilaCube CR-6 Max Maximum Build Volume 400x400x400mm CR 6? +
400×400×400 mm (64.0 L). Big enough for helmets in one piece, full-scale cosplay props, or multiple medium parts in one run. Reliability starts mattering at this scale - a failed 20-hour print stings.
Does the FilaCube CR-6 Max Maximum Build Volume 400x400x400mm CR 6 have auto-levelling? +
Yes - Auto Leveling auto-levelling probe. Not quite as clean as load-cell or LiDAR, but reliable once calibrated and a world better than manual paper-under-the-nozzle.
Is the FilaCube CR-6 Max Maximum Build Volume 400x400x400mm CR 6 worth $750? +
$750 is serious hobbyist territory. For the FilaCube CR-6 Max Maximum Build Volume 400x400x400mm CR 6 to justify this over a $500 machine it needs to deliver genuine speed (volumetric flow), reliability at speed, or access to engineering materials. Check the spec table above against those three.
