Best 3D printers with high-temp heated beds
Updated 16 October 2026 · Live prices updated daily
Printers whose heated bed clears 100 °C. Essential for reliable ABS, ASA and PA-CF adhesion without lifting corners.
- #1
ELEGOOOrangeStorm Giga - Stampante 3D - PETG€3092 CoreXY · 640.0 L · 300°C · Auto Leveling - #2
QIDI TECHQIDI Plus5 Stampanti 3D€749 CoreXY · heated chamber · 30.7 L · 370°C · Loadcell - #3
VoxelabFlashforge Creator 5 Pro - Stampante 3D in€887 CoreXY · heated chamber · 16.8 L · 320°C · Fully Automatic Calibration & - #4
ORIGINAL PRUSACORE One+ Assemblata per Stampante 3D Core€1459 CoreXY · heated chamber · 14.8 L · 290°C · Load cell - #5
CrealityK1 Max Stampante 3D€599 CoreXY · 27.0 L · 300°C · AI LiDAR - #6
QIDIQ2C Stampanti 3D€359 CoreXY · 18.9 L · 370°C · Loadcell Sensor Integrated int - #7
CrealityK2 Plus Stampante 3D€1249 CoreXY · 42.9 L · 350°C · Strain gauge - #8
ANYCUBICKobra S1 ACE 2 Pro Multicolor Stampante 3D€550 CoreXY · 15.6 L · 320°C · LeviQ3.0 - #9
FLASHFORGECreator 5 Stampante 3D€679 CoreXY · 16.8 L · 320°C · Fully Automatic Calibration & - #10
ANYCUBICKobra X Stampante 3D con Tecnologia ACE GE€319 Bedslinger · 17.6 L · 300°C
No listings match your current marketplace selection - tick more sources above.
Matt's take
Bed temperature is the quiet spec that separates "can print ABS if you cross fingers" from "prints ABS reliably". Most PLA-focused machines top out at 70-80 °C because that is all PLA needs. ABS wants 100-110 °C, ASA similar, and filled nylons 90-110 °C. Without that bed heat, corners peel as the print cools and you end up running a brim or raft on every part. Pair with an active heated chamber for best results - bed heat alone helps but doesn't fully solve warp on tall ABS.
Frequently asked
Do I need a 100 °C heated bed? +
Only if you print ABS, ASA, or filled nylons. PLA and PETG are happy at 60-80 °C. If you never leave PLA territory, a high-temp bed is unused capability.
Why does bed temperature matter for ABS? +
ABS shrinks as it cools from its 100 °C+ print temperature. A hot bed keeps the bottom layers near glass transition, so the shrink happens gradually rather than snapping the print off the plate at hour three.
Is a garolite/FR4 bed surface different from PEI? +
Garolite is the de-facto surface for nylon because nylon refuses to stick to PEI. If you plan to print nylon, check that the printer either ships a garolite plate or accepts a swap-in one. Otherwise it is an extra £30 and often an extra week's wait.
Related reading
Ranking is spec-driven. It favours printers that objectively have the capabilities this shortlist targets. Firmware, support quality and long-term reliability aren't on the spec sheet - read the full printer page and owner reports before committing.
