M300 Dual
Updated 25 October 2026 · Live prices updated daily
Buy on Amazon.co.uk - £3650.00 →Affiliate link. Price live from the marketplace, not cached.
At a glance
What this printer gets right and wrong
- ✓ 310°C hot end - handles carbon-fibre nylons and PC, not just the easy stuff.
- ✓ 21.1 L build volume - room for helmets, large functional parts, bulk runs.
- ! Over £1,500 - you are paying for polish and ecosystem, not raw capability. Cheaper machines match the hardware on paper.
Head-to-head spec + price table against the ZORTRAX M300 Dual. Verified printers on this marketplace only.
At this price you're well past the sweet spot for a first printer. There's no shame in starting with something cheaper - you'll learn more on a 200-400 machine and have money left for filament.
Bedslinger with middling flow rate - you already have one of these. The whole point of upgrading is speed, rigidity, or print quality that your current machine can't hit. This doesn't clear that bar.
No active heated chamber or a hot end that tops out below 280°C means no reliable ABS, ASA, nylon or PC. Fine for a hobbyist, wrong tool for commercial work in engineering materials.
Verdicts are rule-driven from the spec sheet and current price (£3650). They don't capture firmware polish, support quality, or reliability - so treat them as a sanity check, not a final answer.
Live offers
Every live listing on the English-language Amazon marketplaces that I've matched to this printer. Cheapest first. Affiliate links.
- 🇬🇧 Zortrax M300 DualAmazon.co.uk · New£3650.00View
Close alternatives - what $3650 gets you elsewhere
Think of this like the shopping-cart upsell: here's what a tenner more or less could buy you in roughly the same category. Same FDM tech, same marketplace, all prices live. Stretches are data-driven; they're not sponsored placements.
Save the money, similar specs on paper. You'd give up: 21.1 L vs 19.0 L build volume, 310°C hot end vs 300°C.
Modest upgrade on the spec sheet.
Get: 30.6 L more build volume (51.7 L) · 370°C hot end (was 310°C).
Frequently asked
What materials can the ZORTRAX M300 Dual print? +
At £3650 the ZORTRAX M300 Dual has the hot end for engineering materials (310°C) but no active chamber, so ABS and nylon will warp on anything larger than a phone case. Treat it as a PLA/PETG/TPU workhorse with headroom for the occasional small ABS part.
How big can I print on the ZORTRAX M300 Dual? +
265×265×300 mm (21.1 L). Big enough for helmets in one piece, full-scale cosplay props, or multiple medium parts in one run. Reliability starts mattering at this scale - a failed 20-hour print stings.
Does the ZORTRAX M300 Dual have auto-levelling? +
Yes - Automatic measurement of platf auto-levelling probe. Not quite as clean as load-cell or LiDAR, but reliable once calibrated and a world better than manual paper-under-the-nozzle.
Is the ZORTRAX M300 Dual worth £3650? +
£3650+ is prosumer/workshop money. Diminishing returns on print quality versus a $700-1000 machine; real returns on long-term reliability, support contracts and replacement parts. Worth it if the printer makes you money, overkill if it is a weekend hobby.
