Liten 3D -skrivare för Nybörjare
Updated 26 September 2026 · Live prices updated daily
Buy on Amazon.se - kr1230.26 →Affiliate link. Price live from the marketplace, not cached.
At a glance
What this printer gets right and wrong
Nothing jumps out on the spec sheet as a standout feature at this price.
- ! Open frame - PLA and PETG only, realistically. Forget ABS or nylon done properly.
- ! 1.0 L build volume - fine for calibration prints and small parts, awkward for anything bigger than a mug.
Head-to-head spec + price table against the Dpofirs Liten 3D -skrivare för Nybörjare. Verified printers on this marketplace only.
At this price you're well past the sweet spot for a first printer. There's no shame in starting with something cheaper - you'll learn more on a 200-400 machine and have money left for filament.
Bedslinger with middling flow rate - you already have one of these. The whole point of upgrading is speed, rigidity, or print quality that your current machine can't hit. This doesn't clear that bar.
No active heated chamber or a hot end that tops out below 280°C means no reliable ABS, ASA, nylon or PC. Fine for a hobbyist, wrong tool for commercial work in engineering materials.
Verdicts are rule-driven from the spec sheet and current price (kr1230). They don't capture firmware polish, support quality, or reliability - so treat them as a sanity check, not a final answer.
Live offers
Every live listing on the English-language Amazon marketplaces that I've matched to this printer. Cheapest first. Affiliate links.
Close alternatives - what kr1230 gets you elsewhere
Think of this like the shopping-cart upsell: here's what a tenner more or less could buy you in roughly the same category. Same FDM tech, same marketplace, all prices live. Stretches are data-driven; they're not sponsored placements.
Save the money, same build volume at 1.0 L. You'd give up: nothing obvious on the spec sheet.
Get: 9.6 L more build volume (10.6 L) · 280°C hot end (was —°C).
Get: 230°C hot end (was —°C).
Frequently asked
What materials can the Dpofirs Liten 3D -skrivare för Nybörjare print? +
At kr1230 the Dpofirs Liten 3D -skrivare för Nybörjare realistically prints PLA and TPU. The listed°C hot end is too tight for PETG with confidence and rules out ABS/nylon entirely.
How big can I print on the Dpofirs Liten 3D -skrivare för Nybörjare? +
100×100×100 mm (1.0 L). Small build area. Fine for calibration prints, minis, keychains, small functional parts. Awkward for anything bigger than a coffee mug.
Is the Dpofirs Liten 3D -skrivare för Nybörjare worth kr1230? +
kr1230+ is prosumer/workshop money. Diminishing returns on print quality versus a $700-1000 machine; real returns on long-term reliability, support contracts and replacement parts. Worth it if the printer makes you money, overkill if it is a weekend hobby.
