Mini+
Updated 15 October 2026 · Live prices updated daily
Buy on Amazon.co.uk - £299.00 →Affiliate link. Price live from the marketplace, not cached.
At a glance
What this printer gets right and wrong
- ✓ Under £300 - low-risk way to get into 3D printing without regretting the spend.
- ! Bedslinger design - expect ringing artefacts on tall prints at speed.
- ! Open frame - PLA and PETG only, realistically. Forget ABS or nylon done properly.
Head-to-head spec + price table against the ORIGINAL PRUSA Mini+. Verified printers on this marketplace only.
Sensible first-printer territory: priced where you can afford to get it wrong, with auto-levelling so the first layer isn't a ritual. You'll outgrow it in 18 months, which is fine.
Bedslinger with middling flow rate - you already have one of these. The whole point of upgrading is speed, rigidity, or print quality that your current machine can't hit. This doesn't clear that bar.
No active heated chamber or a hot end that tops out below 280°C means no reliable ABS, ASA, nylon or PC. Fine for a hobbyist, wrong tool for commercial work in engineering materials.
Verdicts are rule-driven from the spec sheet and current price (£299). They don't capture firmware polish, support quality, or reliability - so treat them as a sanity check, not a final answer.
Live offers
Every live listing on the English-language Amazon marketplaces that I've matched to this printer. Cheapest first. Affiliate links.
- 🇬🇧 Original Prusa Mini+ 3D Printer Kit |For Beginners |Fun & Easy to AssembleAmazon.co.uk · New£299.00View
Close alternatives - what $299 gets you elsewhere
Think of this like the shopping-cart upsell: here's what a tenner more or less could buy you in roughly the same category. Same FDM tech, same marketplace, all prices live. Stretches are data-driven; they're not sponsored placements.
Save the money, similar specs on paper. You'd give up: 5.8 L vs 3.4 L build volume, 280°C hot end vs undefined°C.
Get: 30.2 L more build volume (36.0 L).
Get: 10.9 L more build volume (16.8 L) · 350°C hot end (was 280°C).
Frequently asked
What materials can the ORIGINAL PRUSA Mini+ print? +
At £299 the ORIGINAL PRUSA Mini+ has the hot end for engineering materials (280°C) but no active chamber, so ABS and nylon will warp on anything larger than a phone case. Treat it as a PLA/PETG/TPU workhorse with headroom for the occasional small ABS part.
How big can I print on the ORIGINAL PRUSA Mini+? +
180×180×180 mm (5.8 L). Mainstream bed size - fits 90 % of what people actually print. Cosplay helmets will need to be sliced into sections.
Does the ORIGINAL PRUSA Mini+ have auto-levelling? +
Yes - SuperPinda auto-levelling probe. Not quite as clean as load-cell or LiDAR, but reliable once calibrated and a world better than manual paper-under-the-nozzle.
Is the ORIGINAL PRUSA Mini+ worth £299? +
£299 is the sweet spot tier. The ORIGINAL PRUSA Mini+ competes directly with the current Bambu A1, Creality K1 and Prusa Mini generation. Hardware-per-pound is tight here - the differentiator is usually software polish and ecosystem.
